Description
- 6 input channels and 6 output channels.
- Integrated Preamplifier: it can increase the signal voltage at its input and take it up to 5 Volts RMS without distortion.
- Signal level inputs (RCA) and high inputs through the included multi-connector. When the high level inputs are used, Merlin will automatically turn on when sensing an audio signal, and will additionally create a Remote output to turn on external amplifiers.
- Input channels can be summed. For each output channel, it is possible to select where its audio signal will be taken from, without limitations, it includes all the possibilities!
- Non-volatile memory: the settings made are not lost if the device runs out of power or even if it is removed from the car.
- COPY and LINK function for two channels at a time.
- Each channel can be individually attenuated in multiples of 0.5 decibels.
- It is possible to select for each channel either a High-Pass, Low-Pass, or Band-Pass filter. In the case of subwoofers, the application of a Band-Pass filter would behave like a normal Low-Pass plus a Subsonic (Infrasonic) filter. The cutoff frequency (F3) of each filter can be adjusted in multiples of 1 Hertz, from 21 to 19,999 Hertz. The attenuation slope for each filter can be 6, 12, 18, or 24 decibels per octave (1st, 2nd, 3rd, or 4th order).
- It is possible to vary the output phase of each channel between 0 and 180 degrees.
- It has independent time delays for each channel.
…And as if all this were not enough…
15-band Fully Parametric Equalizer per channel (allows you to adjust the 3 parameters: Frequency, Gain and Bandwidth): the Center Frequency of each band can be set between 20 and 20,000 Hertz with a resolution of 1 Hertz. The Adjustment Range is from -12 to +12 decibels with a resolution of 0.5 dB. You can also adjust the “Q” Factor or Bandwidth, between values 0.2 (wide bandwidth) to 10 (narrow bandwidth), in increments of 0.1.
It has 6 non-volatile memories.